Internet Protocol

From Wikipedia, the free encyclopedia
Jump to: navigation, search

The Internet Protocol (IP) is the principal communications protocol in the Internet protocol suite for relaying datagrams across network boundaries. Its routing function enables internetworking, and essentially establishes the Internet.

IP, as the primary protocol in the Internet layer of the Internet protocol suite, has the task of delivering packets from the source host to the destination host solely based on the IP addresses in the packet headers. For this purpose, IP defines packet structures that encapsulate the data to be delivered. It also defines addressing methods that are used to label the datagram with source and destination information.

Historically, IP was the connectionless datagram service in the original Transmission Control Program introduced by Vint Cerf and Bob Kahn in 1974; the other being the connection-oriented Transmission Control Protocol (TCP). The Internet protocol suite is therefore often referred to as TCP/IP.

The first major version of IP, Internet Protocol Version 4 (IPv4), is the dominant protocol of the Internet. Its successor is Internet Protocol Version 6 (IPv6).citation needed

Function

The Internet Protocol is responsible for addressing hosts and for routing datagrams (packets) from a source host to a destination host across one or more IP networks. For this purpose, the Internet Protocol defines the format of packets and provides an addressing system that has two functions: identifying hosts; and providing a logical location service.citation needed

Datagram construction

Sample encapsulation of application data from UDP to a Link protocol frame

Each datagram has two components: a header and a payload. The IP header is tagged with the source IP address, the destination IP address, and other meta-data needed to route and deliver the datagram. The payload is the data that is transported. This method of nesting the data payload in a packet with a header is called encapsulation.

IP addressing and routing

IP addressing entails the assignment of IP addresses and associated parameters to host interfaces. The address space is divided into networks and subnetworks, involving the designation of network or routing prefixes. IP routing is performed by all hosts, but most importantly by routers, which transport packets across network boundaries. Routers communicate with one another via specially designed routing protocols, either interior gateway protocols or exterior gateway protocols, as needed for the topology of the network.

IP routing is also common in local networks. For example, many Ethernet switches support IP multicast operations.1 These switches use IP addresses and Internet Group Management Protocol to control multicast routing but use MAC addresses for the actual routing.citation needed

Reliability

Internet Protocol uses the end-to-end principle in its design. Under this design, the network infrastructure is assumed to be inherently unreliable at any single network element or transmission medium and assumed to be dynamic in terms of availability of links and nodes. No central monitoring or performance measurement facility exists that tracks or maintains the state of the network. For the benefit of reducing network complexity, the error-correction intelligence in the network is mostly located in the end nodes of each data transmission. Routers in the transmission path forward packets to the next known, directly reachable gateway matching the routing prefix for the destination address.

As a consequence of this design, the Internet Protocol only provides best effort delivery and its service is characterized as unreliable. In network architectural language, it is a connectionless protocol, in contrast to so-called connection-oriented modes of transmission. Various error conditions may occur, such as data corruption, packet loss, duplication and out-of-order delivery. Because routing is dynamic, meaning every packet is treated independently, and because the network maintains no state based on the path of prior packets, it is possible that some packets are routed on a different path to their destination, resulting in improper sequencing at the receiver node.

Internet Protocol Version 4 (IPv4) provides safeguards to ensure that the IP packet header is error-free. A routing node calculates a checksum for a packet. If the checksum is bad, the routing node discards the packet. The routing node does not have to notify either end node, although the Internet Control Message Protocol (ICMP) allows such notification. By contrast, in order to increase performance, and since current link layer technology is assumed to provide sufficient error detection,2 the IPv6 header has no checksum to protect it.3

All error conditions in the network must be detected and compensated by the end nodes of a transmission. The upper layer protocols of the Internet protocol suite are responsible for resolving reliability issues. For example, a host may cache network data to ensure correct ordering before the data is delivered to an application.

Link capacity and capability

The dynamic nature of the Internet and the diversity of its components provide no guarantee that any particular path is actually capable of, or suitable for, performing the data transmission requested, even if the path is available and reliable. One of the technical constraints is the size of data packets allowed on a given link. An application must assure that it uses proper transmission characteristics. Some of this responsibility lies also in the upper layer protocols. Facilities exist to examine the maximum transmission unit (MTU) size of the local link and Path MTU Discovery can be used for the entire projected path to the destination. The IPv4 internetworking layer has the capability to automatically fragment the original datagram into smaller units for transmission. In this case, IP provides re-ordering of fragments delivered out of order.4

The Transmission Control Protocol (TCP) is an example of a protocol that adjusts its segment size to be smaller than the MTU. The User Datagram Protocol (UDP) and the Internet Control Message Protocol (ICMP) disregard MTU size, thereby forcing IP to fragment oversized datagrams.5

Version history

In May 1974, the Institute of Electrical and Electronic Engineers (IEEE) published a paper entitled "A Protocol for Packet Network Intercommunication".6 The paper's authors, Vint Cerf and Bob Kahn, described an internetworking protocol for sharing resources using packet switching among network nodes. A central control component of this model was the "Transmission Control Program" that incorporated both connection-oriented links and datagram services between hosts. The monolithic Transmission Control Program was later divided into a modular architecture consisting of the Transmission Control Protocol at the transport layer and the Internet Protocol at the network layer. The model became known as Internet protocol suite and informally as TCP/IP.

The Internet Protocol is one of the elements that define the Internet. The dominant internetworking protocol in the Internet Layer in use today is IPv4; the number 4 is the protocol version number carried in every IP datagram. IPv4 is described in RFC 791 (1981).

The successor to IPv4 is IPv6. Its most prominent modification from version 4 is the addressing system. IPv4 uses 32-bit addresses (c. 4 billion, or 4.3×109, addresses) while IPv6 uses 128-bit addresses (c. 340 undecillion, or 3.4×1038 addresses). Although adoption of IPv6 has been slow, as of June 2008, all United States government systems have demonstrated basic infrastructure support for IPv6 (if only at the backbone level).7

IP versions 0 to 3 were development versions of IPv4, used between 1977 and 1979.citation needed Version 5 was used by the Internet Stream Protocol, an experimental streaming protocol. Versions 6 through 9 were proposed for various protocol models designed to replace IPv4: SIPP (Simple Internet Protocol Plus, known now as IPv6), TP/IX (RFC 1475), PIP (RFC 1621) and TUBA (TCP and UDP with Bigger Addresses, RFC 1347).

Other protocol proposals named IPv9 and IPv8 briefly surfaced, but had no affiliation with any international standards body, and have had no support.8

On April 1, 1994, the IETF published an April Fool's Day joke about IPv9.9

Security

During the design phase of the ARPANET and the early Internet, the security aspects and needs of a public, international network could not be adequately anticipated. Consequently, many Internet protocols exhibited vulnerabilities highlighted by network attacks and later security assessments. In 2008, a thorough security assessment and proposed mitigation of problems was published.10 The Internet Engineering Task Force (IETF) has been pursuing further studies.11

See also

References

  1. ^ Netgear ProSafe XSM7224S reference manual
  2. ^ RFC 1726 section 6.2
  3. ^ RFC 2460
  4. ^ Siyan, Karanjit. Inside TCP/IP, New Riders Publishing, 1997. ISBN 1-56205-714-6
  5. ^ Basic Journey of a Packet
  6. ^ Vinton G. Cerf, Robert E. Kahn, "A Protocol for Packet Network Intercommunication", IEEE Transactions on Communications, Vol. 22, No. 5, May 1974 pp. 637–648
  7. ^ CIO council adds to IPv6 transition primer, gcn.com
  8. ^ Theregister.com
  9. ^ RFC 1606: A Historical Perspective On The Usage Of IP Version 9. April 1, 1994.
  10. ^ Security Assessment of the Internet Protocol (IP)(archived version)
  11. ^ Security Assessment of the Internet Protocol version 4 (IPv4)

External links








Creative Commons License